Error codes - HMT130

HMT130 User Guide

Document code
M211280EN
Revision
D
Language
English
Product
HMT130
Document type
User guide

The transmitter's software provides a variety of self diagnostics information, for example, FLASH and program memory checksum, probe communication status, probe checksum, operation voltage check, and oscillator fault check.

At startup, the transmitter's software checks the factory/user settings checksum, program memory checksum, and oscillator fault status. Other checks are made during runtime. Possible error codes are listed in Table 1.

Table 1. Error codes, descriptions, and texts
Code Description Error text
1 Probe T measurement error Probe T meas
2 Probe RH measurement error Probe RA meas
3 Probe communication error Probe communication
4 Probe checksum error Probe checksum
5 Probe message form error Probe message form
6 Program's flash checksum error Program code checksum
7 Current settings checksum error (RAM) Settings checksum
8 Factory FLASH not initialized Factory defaults empty
9 User FLASH not initialized User defaults empty
10 Voltage is too low to operate correctly Voltage too low
11 Measurements not available Measurements not available
12 Oscillator fault bit active HW fault 1
13 Analog output quantity invalid 1 Analog output quantity invalid
14 Display quantity invalid Display quantity invalid
15 Invalid relay setting Relay quantity invalid

You can view the error text with the errs serial line command. If you are using a transmitter with the optional display, the error code is shown on the display in the following format: ERR:Code-1[.Code-2][.Code-n]. Multiple errors are separated by a period (".") between the error codes.

1 Measurement parameters are referred to as 'quantities' in the transmitter's software.