Use the ERRS command to display the currently active error codes.
ERRS<cr>
Example (no active errors):
errs
0000h
No errors
ERRS command response | Corresponding error |
---|---|
T MEAS error | Temperature measurement error. [44] |
F meas error | Humidity measurement error. [45] |
RH sensor failure | Humidity sensor failure. [46] |
Frequency measurement outside the permissible value range | Capacitance reference error. [47] |
Ambient temperature error | Ambient temperature out of range. [48] |
Program flash check sum error | Firmware checksum mismatch. [49] |
Parameter flash check sum error | Device settings corrupted. [50] |
INFOA check sum error | Additional configuration settings corrupted. [51] |
SCOEFS check sum error | Sensor coefficients corrupted. [52] |
CURRENT check sum error | Main configuration settings corrupted. [53] |
Voltage error | Supply voltage out of range. [55] |
General flash failure w/r | Non-volatile memory read/write failure. [57] |
Calibration certificate check sum failure | Calibration certificate checksum mismatch. [58] |
Refer to Error messages in Insight software for more information about the error states.