Set Serial Interface Mode - HMM100

HMM100 User Guide

Document code
M211024EN
Revision
E
Language
English (United States)
Product
HMM100
Document type
User guide
SMODE [xxx]<cr>
xxx
STOP, RUN, or POLL
  • In STOP mode: outputting only when command is issued, any command can be used.
  • In RUN mode: outputting automatically, only command S can be used.
  • In POLL mode: outputting only when command is issued, any command can be used after the line has been opened using the OPEN command.

Use the SMODE command to show or set the serial interface mode. Note that a separate SAVE command is not needed to store the new serial interface mode setting.

The polling mode can be used when more than one module is connected to one serial bus. When set to POLL state, the modules communicate one at a time when the specific module address is called on the serial line. See descriptions of the commands ADDR (Set Module Address) and OPEN (Connecting to the Module in POLL Mode).

Examples:
>smode stop
Output mode    : STOP
>

>smode run
Output mode    : RUN
>

>smode poll
Output mode    : POLL
>