Installing new transformer - LT31 - FSP102UGK

FSP102UGK Installation Manual
Product status
Document code
M210953EN
Revision
C
ft:locale
en-US
Product
LT31
FSP102UGK
Document type
User guide
  • Wrench (size 10)
  • Wrench (size 7)
1
Steel plate
2
Rubber insulation plate
3
Transformer
4
Rubber insulation plate
  1. Make sure that the first rubber insulation plate is around the transformer mounting screw on the mounting plate.
  2. Connect the transformer grounding wire with a ring tongue connector to the grounding screw.
  3. Place the new transformer onto the transformer mounting screw.
  4. Place a second rubber insulation disc on the transformer.
  5. Feed the transformer mounting screw through the center hole of the round, metal transformer cover plate, and onto the transformer.
  6. Tighten the transformer nut firmly with the original lock washer and nut.
  7. If you cannot tighten the transformer nut firmly, do the following:
    1. Attach the M6 spacer (delivered with the upgrade kit) to the transformer mounting screw and screw the spacer down until it almost touches the transformer mounting nut.
    2. Insert the M6 hex screw (delivered with the upgrade kit) to the spacer and turn the screw until it is touches the transformer mounting screw.

      Use a wrench (size 10) to fix the spacer in its current position. Use another wrench (size 10) to tighten the hexagonal screw firmly.

    3. Tighten the transformer mounting nut.

      Use one wrench (size 10) to fix the spacer in its current position. Use another wrench (size 10) to tighten the transformer mounting nut firmly.

    4. Fix the spacer in its position with a wrench (size 10). Use another wrench (size 10) to loosen the hex screw and remove the spacer and hex screw from the transformer mounting screw.