Verification - WAC155

WAC155 User Guide

Document code
English (United States)
Document type
User guide
The status indicator LED is located on the component board under the junction box cover.
  • The LED flashes green, if the self-diagnostics are completed without errors.
  • The LED flashes red, if there is an error.

An error can be caused by a sensor malfunction, an erroneous installation or configuration, or a combination of these. To diagnose the problem, use the service command ERRS over the service connection.

If WAC155 signal cable is connected to a data collection system and the system is switched on, make sure that the wind readings react correctly:
  • To test the anemometer, rotate the cups manually.
  • To test the wind vane, hold the vane at a few fixed angles and verify the data.