To install the bolts, you need:
- Foundation bolt (3 pcs)
- Wedge bolt (3 pcs)
- Bar for installing the wedge bolts
(1 pc)
- Key piece for the wedge bolts (1 pc)
-
Check that the foundation bolts are at the correct height,
vertical, and on the same level with each other.
| Make sure that 80 mm (3.15 in) of the
foundation bolts is above the surface of the concrete foundation. |
-
Make sure that the holes are free of dust, and clean and dry.
-
Check the instructions of the chemical anchor manufacturer before use.
| The chemical anchor may harden very
fast. Work in a coordinated manner and follow the instructions and the given working
times. |
-
Put the key piece inside the wedge bolt so that the narrow end of
the key piece points towards the wedge bolt.
- 1
- Foundation bolt
- 2
- Bar
- 3
- Key piece
- 4
- Wedge bolt
-
Push the wedge bolt into the hole. To push the wedge bolt all the way in, hammer the
bolt with the bar.
-
Remove the key piece.
-
Repeat the previous 3 steps with the rest of the wedge bolts.
-
Screw the foundation bolts to the wedge bolts and tighten the screws properly. Fill the
remaining space of the holes with a suitable compound.
-
Check that the foundation bolts are at the correct height,
vertical, and on the same level with each other.
| Make sure that 80 mm (3.15 in) of the
foundation bolts is above the surface of the concrete foundation. |
-
Check the instructions of the chemical anchor manufacturer for the time it takes for
the chemical anchor to set. Leave the chemical anchor to set.