| Issue | Workaround |
|---|---|
| Insight cannot be used to set temperature scaling values between -64° and -95°C on any device. | |
| The available parameters displayed for some devices on the Monitoring page are occasionally incorrect or missing. | |
| Some reports generated by Insight contain incorrect firmware version number of the devices. | If there is a discrepancy between the software (firmware) version displayed on the UI and in the report, consider the UI version to be correct. |
| Export will export the same resolution as shown on the UI with the exception of losing the least significant digit after the decimal place if the last digit is a 0. | |
| If you try to delete an empty log folder for an Indigo80 device, you may see an error pop-up indicating that the delete operation couldn’t be performed. However, if the Indigo80 device is unplugged and reconnected, the folder will show as successfully deleted. | |
| If you open a file that contains large gaps between measured samples, then the graphs of that data may not plot as expected in the UI. Exports of the same data will be accurate. |
| Issue | Resolved in |
|---|---|
| Fixed an issue that was causing some probes to not round negative decimal places correctly. |
1.5 release |
| Fixed an issue that was causing users in the +00:00 time zones to have their calibration date’s picker subtract/add an hour for daylight savings time (DST), potentially causing the “Today” button to indicate 24 hours earlier than the current day. |
1.5 release |
| Fixed an issue that occurred after upgrading to Insight version 1.4, in which Insight was not recognizing some new devices or couldn't connect to some probes. |
1.5 release |
| Fixed an issue that was causing a slight mismatch between the values displayed on the monitoring tab and in exported reports. This occured because the monitoring UI previoulsy used fewer decimal places than reports do. | 1.5 release |